M2C 3482 PERFECT MESH MINI ADJUSTER
Art.Nr.: M2C-3482
Hersteller: M2C Racing
9,00 EUR
inkl. 19 % MwSt
Produktbeschreibung
M2C 3482 PERFECT MESH MINI ADJUSTER
Brand: M2C Racing
THESE PARTS ARE ONLY COMPATIBLE WITH THE M2C ULTIMATE MOTOR MOUNT SYSTEM.
INCLUDES 1 ASSEMBLED 3482 PERFECT MESH MINI ADJUSTER WITH LANYARD.
A low cost way to bring the M2C PERFECT MESH ADJUSTER to the community.
THE MINI ADJUSTER IS EASY TO USE.
Loosen slide screws to where you can move the slide with your fingers. (you will damage slide if you leave it tight)
Run the adjuster screw out.
Install adjuster ball into slide. It will be tight the first time.
Back out the screw until the block seats into the end of the mount. (lanyard side up)
Push on the adjuster screw while adjusting to keep the block seated (I like using my thumb on the block and grab the mount with my hand)
Adjust to perfection.
Tighten slide screw
Turn adjuster screw clockwise until block is free.
Tighten everything up and go bash!!!
Install starts at 10:00, but the whole video is good. Give him a like and sub, he posts some killer bashing!
Part is 3D printed, adjuster screw is steel.
Fits:
KRATON 6S EXB V2
Brand: M2C Racing
THESE PARTS ARE ONLY COMPATIBLE WITH THE M2C ULTIMATE MOTOR MOUNT SYSTEM.
INCLUDES 1 ASSEMBLED 3482 PERFECT MESH MINI ADJUSTER WITH LANYARD.
A low cost way to bring the M2C PERFECT MESH ADJUSTER to the community.
THE MINI ADJUSTER IS EASY TO USE.
Loosen slide screws to where you can move the slide with your fingers. (you will damage slide if you leave it tight)
Run the adjuster screw out.
Install adjuster ball into slide. It will be tight the first time.
Back out the screw until the block seats into the end of the mount. (lanyard side up)
Push on the adjuster screw while adjusting to keep the block seated (I like using my thumb on the block and grab the mount with my hand)
Adjust to perfection.
Tighten slide screw
Turn adjuster screw clockwise until block is free.
Tighten everything up and go bash!!!
Install starts at 10:00, but the whole video is good. Give him a like and sub, he posts some killer bashing!
Part is 3D printed, adjuster screw is steel.
Fits:
KRATON 6S EXB V2
Bewertungen
* Den Zusatz “Verifizierter Kauf” erhalten nur Bewertungen, die von Käufern abgegeben wurden, die das Produkt in diesem Shop gekauft haben. mehr